Black Jewelry Display Cases

Black jewelry display cases against white French-panel casework: one boutique of roughly eighty to one hundred twenty square metres in a mall, aimed at the wedding and gifting market rather than daily-wear fashion. The pairing — dark metal frames over white panels, with blush-pink chairs and a crystal chandelier — was the client’s brief from the start, and every unit in the store was built around that contrast. All casework came from our Guangzhou workshop.

The plan runs a central island with a wall run behind it. The island sits in two parts, an L-shaped display block and a straight consultation run, so browsing and sitting customers don’t crowd each other. The backwall carries lit poster panels flanked by tall cabinets, and the wall run to the right pairs glass counters with upholstered chairs for the try-on trade. Traffic circles the island, drawn to the lit panels at the back.

Merchandising follows the gold trade. Chains and bracelets sit on black velvet necklace display trays under the glass, orange and gold trays carrying the brighter stock, six to ten pieces per run. Rings sit closer to the till under tighter light. One-off pieces take a curved glass hood on a pedestal, one piece alone, for the customers who came in for a single decision.

Materials hold the two-tone scheme through the whole set: white French-panel doors with recessed black trim, black metal frames on every glass hood, white stone decks, low-iron glass, and blush-pink upholstery as the single soft colour. Black velvet lines the trays inside. Case lighting runs at 4000K against a 3000K room, and the chandelier stays decorative rather than task.

Delivery ran the factory route: panels sprayed and lined, glass fitted, lighting wired and burned in before packing. The store dressed out in a single fit-out, with mall contractors handling floor and ceiling. Sample in seven to ten days, production in thirty to forty-five, shipped KD or fully assembled from Guangzhou.